If you live in a home with a basement, you may not think about your sump pump all that often. However, if you live in an area that is prone to flooding during the rainy season, like the Northbrook area, then your sump pump is absolutely something you’ll want to keep up with on a regular basis.
A sump pump can help prevent water from collecting in your basement and causing irreparable damage to your Northbrook home. However, many homeowners are not very familiar with how these systems operate, and it often leads to problems that can be quite costly. To help you avoid issues, this sump pump installer in Northbrook, Illinois is going to review some of the most common mistakes homeowners make with their sump pumps.
Allowing Debris to Enter the Pump
The pump will go bad far more quickly if it is filled with sand and silt. You will find that a clogged pump will make a humming sound that is different from a pump operating normally. You may also smell burning metal. If you have a level sensor, it may not shut off the pump when water is below the sensor, or it may not shut off the pump at all. You also may have water overflowing from the sump pit.
Problems With the Float Switch
The float switch is a key component of your sump pump system. It is what tells the pump when there is water in the pit. Sometimes, a homeowner will forget to close the float switch after installation, or it may not be wired correctly. You may also experience a humming sound from the pump that does not go away.
Errors With the Check Valve
The check valve tells the pump to stop running when water is above the pump. If it is not working correctly, your pump will keep running, regardless of whether the water level is too high. The result will be that your system will need to be replaced by your sump pump installer in Northbrook, Illinois earlier than expected.
A Broken Discharge Pipe
The discharge pipe is the pipe that carries the water from your sump pump to the outside of your home. It is crucial to make sure the discharge pipe is not broken. If it is, water will keep pumping into your sump pit and may overflow into your home. Your sump pump installer in Northbrook, Illinois can check the discharge pipe by removing the plug at the bottom of the sump pit. If there is water in the pit, the pipe is broken.
Not Checking for Loose Wiring
A loose wire may be the culprit if your sump pump is not working correctly. You may be able to solve the problem simply by tightening the wire or rewiring it. The best way to tell if there is a loose wire is to check the pump and wires with the pump unplugged. If you notice a loose wire, you should have a professional rewire the system.
Not Hiring an Expert
You may not be able to accomplish DIY sump pump installation properly if you lack the necessary experience, expertise, and tools. Hiring a professional sump pump installer in Northbrook, Illinois is strongly recommended for the best results.
Looking for a Professional Sump Pump Installer in Northbrook, Illinois?
Are you looking for a professional sump pump installer in Northbrook, Illinois that can help set up and maintain your system? If so, look no further than the professionals at R Carrozza Plumbing Co. Our professionals can inspect your property and help you pick out the right system that will keep your basement dry. Contact us today at (847) 451-7040 to get started.